BendCraft Pro
Conduit & Electrical Calculators
Exact trigonometry, no shop-table rounding, no sign-up. Pick a calculator below — each one works standalone in your browser, on any device.
Conduit bending
Offset Bend Calculator
Shift a run around an obstruction — two equal-angle bends.
BendingStub-Up (90°) Calculator
Bend mark from your target height and bender's take-up.
BendingKick Bend Calculator
Single-angle bend — mark, travel, run, and shrink.
BendingThree-Point Saddle Calculator
Cross a single pipe or obstruction with three bends.
Electrical trade math
Voltage Drop Calculator
Single or three-phase — checked against the 3% recommended limit.
ElectricalConduit Fill Calculator
EMT, IMC, RMC — checked against the NEC Ch. 9 Table 1 limit.
Want all of this on-site, offline, with PDF reports?
BendCraft Pro for iOS covers all 10 bend types — offset, stub-up, kick, saddles, rolling offset, concentric, segment, and compound — plus voltage drop, conduit fill, and PDF reports you can hand off on-site. No connection needed once installed.